Human Touch GRAVIS ZG CHAIR Manual De Uso Y Cuidado página 4

get ready
Unpack the box
Chair Base
Power Transformer/Cable
Head Pillow
INSTALL THE ARMRESTS
1. Plug in the chair, then use the controller Back
the legrest.
Backrest
humantouch.com
Armrests (2)
Body Pad
Remote Pocket
and Foot buttons to raise the backrest and lower
Legrest
4
Your Human Touch Gravis ZG chair
assembly. Just attach the armrests, body pad, head pillow,
remote pocket, and you're done!
2. Align the armrest as shown below, with the armrest tabs positioned to the rear of the corresponding
tabs on the chair arm.
Armrest tab Armrest
Chair tab
3. Turn the armrest over, lower it onto the chair arm, then slide it forward as far as it will go. The locking
mechanism clicks into place.
4. Repeat steps 2 and 3 to install the other armrest.
5. Pull up and backward on each armrest to make sure it is locked into place.
requires some simple
Armrest tab
Chair tab
5 5