Human Touch GRAVIS ZG CHAIR Manual De Uso Y Cuidado página 5

get ready
POWER ON THE CHAIR
Plug in the chair, take a seat, then press the Power button on the remote. The Power LED lights to
indicate the remote is receiving power.
INSTALL THE BODY PAD
1. Use the controller button to recline the chair
into the zero-gravity position.
2. Lay the body pad on top of the chair base.
Body pad
3. Slide the flap on the underside of the legrest portion of the pad over the chair frame, then pull the
pad firmly toward the headrest. Press upward on the flaps on the underside of the pad corners to
secure the pad to the chair frame using the hook-and-loop fasteners.
humantouch.com
Legrest
Backrest
Push up to secure
6
4. Flip the backrest portion of the pad forward onto the seat.
5. Unzip the canvas pocket, then thread the air hose bank and the two white cables through the hole in
the chair canvas.
Canvas pocket
6. Connect the air hose bank, then connect the two cable connectors, making sure the cabling is all
positioned behind the seat springs.
Pad
Legrest
Backrest
Air hose bank
Two white cables
Cable connectors
7