Connection Example - Kathrein EAX 2912 Guia De Inicio Rapido

Connection example

Basic installation and safety instructions
The equipment described is designed solely for the installation of satellite receiver systems
Any other use, or failure to comply with these instructions, will result in voiding of warranty cover
The equipment may only be installed in dry indoor areas.
Do not install on or against highly combustible materials
The equipment must be provided with an earthing wire (Cu, at least 4 mm
The safety regulations set out in the current EN 60728-11 and EN 60065 standards must be complied with
Fixings: Wood screws, max Ø: 4 mm
Connector: HF plug 75 Ω (series F) to EN 61169-24
Unused subscriber ports should be closed off by 75 Ω resistors (e.g. EMK 03)
• If the inner cable
conductor diameter is
greater than 1.2 mm
or in case of burr, the
device sockets may be
destroyed.
Electronic equipment is not household waste - in accordance with directive 2002/96/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL
of 27 th January 2003 on used electrical and electronic equipment, it must be disposed of properly. At the end of its service life, take this unit for disposal
to an appropriate offi cial collection point.
Internet: www.kathrein.de
KATHREIN-Werke KG • phone +49 8031 184-0 • Fax +49 8031 184-306 • Anton-Kathrein-Straße 1 - 3 • P.O. Box 100 444 • 83004 Rosenheim GERMANY
(Symbolic representation)
Max. 2 mm
excess length
Clamping torque
max. 3 Nm
(danger of over-
winding)
)
2
Diameter
0.6-1.2 mm free
of burrs