Echo MS-41BPD Manual De Uso Y Cuidado página 4

SPRAYER COMPONENTS & USE INFORMATION, Continued
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft
(A) aligning the pump handle holes and shaft holes. Slide the bolts
(B) through the aligned holes as shown in figure 1 thru 4. Tighten
nuts (D) to bolts. There are holes in the pump handle to allow for
either right (fig.5) or left (fig.6) hand mounting.
Nylon Lock Nut
Threaded Bolt
Figure 1
Figure 4
Tighten nut to bolt
Pump Handle
Positioned For Use
(right hand shown)
WAND CLIP
The wand can be attached to the
pump handle using the wand clip.
Figure 2
Line up holes
Figure 5
Right Hand
3E
B. Bolts
C. Pump Handle
Figure 3
Slide bolt through holes
Figure 6
Left Hand
A. Pump Shaft
D. Nuts