Philips SDV2940/55 Manual Do Usuário página 21

Mounting Instructions
Screw Holes
Screw Holes
U-Bolts
Washer
Saddles
Nuts
3. Attach the main body and L-bracket to wall / mast mounting
bracket using cross head screw (fig. 3) note the orientation of
the bracket. ) Do not fully tighten this screw to allow for later
adjustment (fig. 3).
4. Tighten all screws and nuts to firmly affix the antenna to the
wall.
5. Attach the cable to the F connector on the underside of the
unit and weather protection boot over the connection.
fig.3
See next steps under – Connections to your TV
For outdoor mast mount installation:
NOTE: Do all antenna assembly work on the ground. Raise the
completed antenna after assembly.
1. Insert U-Bolts into the holes of the wall/mast bracket (fig. 4).
2. Slide the mast clamps onto the U-Bolts (fig. 4).
3. Attach the 4 nuts with lock washers to the U-Bolts - do not
tighten fully (fig. 4).
fig.4
4. Slide the assembly on to the mast. Do not tighten fully, just snug
enough for the assembly to stay in place (fig. 5).
5. Attach the L-B racket to the wall / mast bracket using cross
head screw and nut, Note the orientation of the bracket. Fully
tighten this screw.
6. Attach the main body of the antenna to L bracket vertically.
7. Tighten all screws and nuts to firmly affix the antenna to the
mast.
fig.5
8. Adjustment of the antenna direction will be done by rotating
the mast in its mount.
9. Attach the cable to the 'F' connector on the underside of the
unit and weather protection boot over the connection (fig.6).
fig.6
EN
21