Operation; Battery Installation - pico Technology TA325 Guía De Usuario

______________________________________________________________
4.

OPERATION

4.1

BATTERY INSTALLATION

Never replace the batteries when the flexible measuring
head is installed on the conductor to be tested, or when
the output is connected to the scope device.
Never operate the unit without the battery cover fitted.
The TA325 and TA326 require two AA MN1500 LR6 alkaline
batteries for operation.
from the rear of the electronics enclosure.
Battery status is indicated by an orange LED on the front of the
integrator module. This LED will flash once when the unit is
switched ON. The length of time the LED is lit will increase as
battery life decreases. If the LED is continuously lit, the
batteries are low and need to be replaced.
Should you suspect a depleted battery or the low-battery LED is
blinking, proceed as follows.
1. Turn OFF all power to the unit and measurement circuits.
2. Set the probe selector switch to the OFF position.
3. Remove the flexible current probe from around the
conductor of your measurement circuit.
output from the scope device.
4. Rotate the battery lock screw (1/4 turn) until it aligns with
the unlock symbol. The battery cover can now be removed.
5. Install the replacement batteries into the battery holder.
6. Replace the battery cover and turn the battery lock until it
aligns with the lock symbol.
_______________________________________________________________
7
The battery compartment is accessed
Disconnect the