Tabla de contenido
Publicidad
4) Attach the Back Assembly (D) to the Seat Assembly (E) with eight 4x35mm Phillips Screws (B)
through the predrilled holes. The angled edges of the Back Supports (H & I) must be under the
upper brace on the back before screwing into place.
5) Attach the Left Arm (L) to the Left Back Support (H) with two 4x35mm Phillips Screws (B)
through the predrilled holes in the Left Back Support (H). Attach the Left Arm (L) to the Left Leg (J)
with two 4x35mm Phillips Screws (B) through the predrilled holes in the top of the Front Leg.
Repeat for Right Arm (M).
6) In the remaining holes, insert 4x35mm Wood Screws (B) into each back support, making
sure they thread into the seat assembly.
TIGHTEN ALL HEX BOLTS AND SCREWS IN THE ROCKER.
L
I
D
M
K
E
969KFSIc – Page 4 – 05/08
Publicidad
Tabla de contenido
