Rear Panel - resident dj 10033276 Manual De Instrucciones

EN
12

Rear panel

20 Power supply: Use only the power adapter provided with the device.
21 Use the Master Output to connect the unit to an amplifier. The level is
controlled by the resulting mix of the channel faders
22 The LINE4 inputs for channel 3 may be used for connecting tape decks,
CD or MP3 players etc. Select source with button.
23 The LINE3 inputs for channel 3 may be used for connecting tape decks,
CD or MP3 players etc.
24 The PHONO2 inputs for channel 2 and are only for turntable connection.
The LINE2 inputs may be used for connecting tape decks, CD or MD
players etc.
25 The PHONO1 inputs for channel 1 and are only for turntable connection.
The LINE1 inputs may be used for connecting tape decks, CD or MD
players etc.
26 The MIC1 INPUT connector is a balanced 1/4" TRS socket for
microphone connection.
27 The MIC2 INPUT connector is a balanced 1/4" TRS socket for
microphone connection.
28 HEADPHONES 6.35mm stereo jack allows you to connect your
headphones (output signal is main mix).
USB PLAY MODE
• Press MODE button until Status LEDs display LED1=ON/LED2=OFF.
• The USB storage device is placed into USB socket. Each press of the
PLAY BUTTON causes the operation to change from play to pause or
from pause to play.
• PREV/NEXT button: Use this button for previous/next track. The track
will fast backward/ forward play if press and holding the button for more
than 3 seconds