gala gar WCS-510 Manual Técnico De Instrucciones página 12

B
A- ON/OFF GENERAL SWITCH.
Position O: The cooling module is in stop position. The welding operation can be carried out with AUTO-
COOLED TORCH.
Position I: The cooling module is operative. The welding operation must be carried out with COOLED
TORCH.
B- FUSE-HOLDER.
Electric protection system of cooling module. Slow 2 A (6x32 mm).
C- COOLANT LIQUID LEVEL INDICATOR
This indicates the coolant liquid level. It must be between MINIMUM and MAXIMUM levels.
D- HOT WATER CONNECTOR.
For quick connection of the (RED) cooling tube of the connection extension.
E- COLD WATER OUTLET CONNECTOR.
For quick connection of the (BLUE) cooling tube of the connection extension.
3.1. RECOMMENDATIONS FOR THE USE OF THE EQUIPMENT.
Do not use drinking water as cooling liquid, we recommend using the following mixture:
Every time the connection extension coolant liquid connection tubes are connected, the air must be purged
as indicated in figure 3. If there is air in the cooling circuit the pump will not supply water to the circuit.
WCS-510
Fig. 4. Controls of cooling module WCS-510
A
75% DISTILLED WATER + 25% ALCOHOL.
D
E
12