Heath Zenith Secure Home DualBrite SH-4192-BK-A Manual De Instrucciones página 6

TESTING
1. Turn on the circuit breaker and light
switch.
Note: Sensor has a 1
riod before it will detect motion. When
first turned on wait 1
2. Switch the on-time to TEST position and
D B switch to the OFF position.
®
ual rite
TEST 1 5 10 MIN
ON-TIME
Avoid aiming the control at:
• Pools of water or objects that change
temperature rapidly, such as heating vents
and air conditioners. These heat sources
could cause false triggering.
• Areas where pets or traffic may trigger
the control.
• Nearby large, light-colored objects
reflecting daylight may trigger the shut-off
feature. Do not point other lights at the
sensor.
6 ft.
(1.8 m)
(9.1 m)
Maximum Range
/ minute warm up pe-
1
2
/ minutes.
1
2
OFF 3 6 DUSK TO
HOUR
30 ft.
Maximum
Coverage Angle
The detector is less sensitive to motion di-
rectly towards it and more sensitive to across
motion.
Motion
Least Sensitive
3. Walk through the coverage area noting
where you are when the lights turn on.
DAWN
4. If you need to change the sensitivity,
temporarily remove the fixture and make
the adjustment. Too much sensitivity may
increase false triggering.
5. Set the amount of TIME you want the light
to stay on after motion is detected. (1, 5,
or 10 minutes).
6. Set the amount of time after dusk you want
the lights on accent level.
180°
6
Motion
Sensor
Most Sensitive
200477-02