Part 3. Operation; How To Use The Ait Drive - Sony SDX-D500C Guía Del Operador

Part 3. Operation

How to use the AIT Drive

This section describes how to use the AIT drive, and how to handle data
cartridges.
1
Press the POWER switch on the front panel.
The POWER indicator should light, and the STATUS, BUSY and TAPE
indicators should blink as the self-test is performed.
2
When the three indicators stop blinking, you can insert a data cartridge
as shown below. The TAPE indicator will blink, and if the cartridge is
write-protected, the STATUS indicator will light.
Figure 3-1. Inserting a data cartridge
3
Computer software controls the reading and writing of tapes. While
reading or writing, the BUSY indicator blinks.
15
Part 3. Operation