Cobra Electronics microTALK PR 240 Manual Del Propietário página 4

Product Features
Introduction
Backlit LCD
Features
Display
• Two-Way Radio
With a range up
NOAA All
to five (5) miles
Hazards Alert Icon
(8 km).
(PR 350 WX only)
• 22 Channels
Low
Seven shared
Power Icon
with FRS/GMRS,
seven FRS only
eight GMRS only.
• 38 Privacy Codes
• 10 Channel NOAA
All Hazards Radio
(PR 350 WX only)
• NOAA All
Hazards Alert
(PR 350 WX only)
• Backlit LCD
Display
• Scan
(channel,
privacy code)
• Water Resistant
Receive/
• Speaker/
Transmit
Microphone Jack
Tower Icon
Channel
• Call Alert
Numbers
(10 selectable
tones)
• Lock
• "Roger Beep"
(selectable On/Off)
• Battery/
Power Saver
Important FCC Licensing Information
• Auto Squelch
This radio operates on General Mobile Radio
• Maximum
Service (GMRS) frequencies which require a
Range Extender
Federal Communications Commission (FCC)
license. See page 18 for licensing and other
• Belt Clip
related information.
• Wrist Strap
English
4
Lock
Icon
Roger
Beep Icon
Battery
Low
CTCSS Privacy
Code Numbers
Main
Scan Icon
Power NOAA All
Saver Icon Hazards Radio Icon
(PR 350 WX only)
Introduction Operation
Caring for Your microTALK
Your microTALK ® radio will give you years of trouble-free service if
cared for properly. Handle the radio gently. Keep the radio away from
dust. Never put the radio in water or in a damp place. Avoid exposure
to extreme temperatures.
Batteries
Remove Belt Clip
To Install or Replace Batteries:
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
Pull Down Lock Latch
2. Pull down on the Battery Door Latch
remove the battery compartment cover.
3. Insert four AAA batteries. (Always use high
quality alkaline batteries.) Position batteries
according to polarity markings.
Insert Batteries
4. Replace Battery Compartment cover and belt clip.
See information on page 20 for optional
battery pack and desktop charger
accessories ordering instructions.
The Basics to Get You Started
Your microTALK
To get started, simply:
1. Press the Power button to turn On your radio.
2. Press the Channel Up or Channel Down
button to select a channel.
Both radios must be tuned to the
same channel to communicate.
3. Press and hold the Talk button while
speaking into the microphone.
4. When finished talking, release the Talk
button and listen for a response.
Customer Assistance Warranty
® Radio
to
® radio is easy to use.
Nothing comes close to a Cobra ™
•
•
5