Standby Mode - Marmitek HDTV Anywhere Modo De Empleo

5.3 Using the HDTV transmitter and receiver
1. Switch the HDTV or HD projector ON and select the HDMI input to
which the HDTV receiver is connected. Please consult the user manual
of your HDTV or HD projector if necessary.
2. Press the POWER button on the HDTV transmitter or receiver to switch
it ON.
3. During system start-up, the HDTV transmitter and receiver will try to
establish a connection (SIGNAL LED flashes green). This may take 15-
20 seconds.
4. If the HDTV transmitter and receiver are connected, the POWER and
SIGNAL LEDs will turn green.
5. Switch your HD device ON and use the SOURCE button to select the
appropriate HDMI input.
6. You can now receive audio and video in Full HD 1080p quality on the
HDTV and/or HD projector connected to your HDTV transmitter and
receiver.
7. Point your HD device's remote control towards the HDTV receiver (or
IR receiver) in order to operate your equipment from this room.

5.4 Standby mode

From the Standby mode (POWER LED is red), the HDTV transmitter
and receiver will automatically switch ON when an HDTV or HD
projector is switched ON.
The HDTV transmitter and receiver will switch to Standby mode
automatically a few minutes after the HDTV or HD projector is switched
OFF.
HDTV Anywhere™ 9