Shelving Use Requirements; Assemble & Complete; Important; Assembly Instructions - Gladiator EZ CONNECT GARK485X Serie Instrucciones De Ensamblaje

Shelving Use Requirements

Maximum weight limit is 1,000 lbs (454 kg) for each shelf, not
■
to exceed 5,000 lbs (2,268 kg) for the entire shelving unit.
WARNING
Excessive Weight Hazard
Use two or more people to move shelving.
Failure to do so can result in back or other injury.
Unpack
NOTE: Use one person to assemble shelving and two people to
move it.
1. Remove and verify the contents. See the "Parts" section
so you can sort out all of the parts.
2. Dispose of/recycle all packaging materials.
Assemble & Complete
No tools or hardware required.
■
Can be assembled by one person.
■

IMPORTANT:

Determine shelf spacing before assembly.
■
NOTE: It is recommended to space the shelves equally from
top to bottom of the shelving unit and build it from the bottom
up. See "End Frames/Support Beams" illustration.
Prior to assembly, refer to sticker located on the inside of one
■
of the P4 side support beams and record model and serial
numbers on the included warranty page. There are many
benefits of registering the product. Find out more and register
the product online at www.gladiatorgarageworks.com.
Support Beam Orientation

ASSEMBLY INSTRUCTIONS

End Frames/Support Beams
P6
P4
P3
P2
Tie Channels for Shelf Support
NOTES:
It is recommended to put beams at notch 1, 8, 14, 21, and
■
28 (counting from the bottom up). To keep shelving rack
balanced, keep three of the shelves on the bottom half of
the shelving rack.
All support beams need to be at the same height or the
■
shelves will not assemble correctly.
During assembly, press firmly on all side support beams
■
and horizontal support beams (P3 and P4) to ensure they
are properly installed in the slots on top and bottom posts.
5