Gladiator EZ CONNECT GARK485X Serie Instrucciones De Ensamblaje página 6

1.
Attach support beams to bottom
post
P3
P4
P1
Use the bottom post (P1) and attach a horizontal support
beam (P3) across front, and attach a side support beam (P4)
to the other side. Insert horizontal and side beams starting at
the top of the slots on the upright posts and pushing down
after engagement. This will give you support while building
your shelves up. You have now assembled one corner.
3.
Add tie channel support
Add tie channel support (P5) to the bottom of the frame.
Rotate into place BEFORE dropping tabs in slot.
5.
Assemble 2nd shelf
Repeat steps 1 and 2. We recommend adding a section at
notch 8 from the bottom of the post. Add the horizontal and
side support beams. Add tie channel support and shelf.
6
P1
P4
P3
P5
2.
Assemble bottom
P4
Repeat step 1 to assemble the other three corners,
completing the bottom shelf. Make sure to press firmly on all
side and horizontal support beams (P3 and P4) to ensure they
are properly installed in the top and bottom posts.
4.
Add 1st shelf
Add laminate shelf to the bottom of the frame. Gently place
laminate shelf on beams and tie channel support.
6.
Assemble 3rd shelf
Repeat steps 1 and 2. We recommend adding a section at
notch 14 from the bottom of the post. Add the horizontal
and side support beams. Add tie channel support and shelf.
NOTE: We recommend adding 3 shelves to the bottom half
of the shelving rack for better support. Make sure to install
shelves before beginning next step.
P3
P6