Watching Tv; Channel Selection; Volume Adjustment - FUNAI Sylvania LC155SL8P Manual Del Usuario

W
ATCHING TV

Channel Selection

Select channels by using [CH. K /L] or [the Number buttons].
• To select the memorized channels, use [CH. K /L] or
[the Number buttons].
• To select the non-memorized channels, use
[the Number buttons].
To Use [the Number buttons]
TV
- When selecting analog channel 12
DTV
- When selecting digital channel 12-1
Be sure to press [–/ENT.] before entering the minor
channel number.
• Press [CH. RETURN] to return to the previously
viewed channel.
• When you select a channel larger than 100, press
[+100] first. Then use [the Number buttons] to press
the lower 2-digit numbers.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously.
Therefore, you can select more than one program per
major channel since digital broadcasting technology
distinguishes between multiple channels broadcast by
a single network.
NTSC (analog mode) [Air Time]
18:00
18:30
CH4 19:00
19:30
20:00
20:30
: change automatically
: change manually by using [CH. K/L]
Note:
• "NO SIGNAL" will appear on the TV screen after the minor
channel broadcast is over.
ATSC (digital mode)
CH4 No signal No signal
CH4
(high definition TV)
CH4 CH4-1 No signal
CH4 No signal CH4-2
CH4 CH4-1 CH4-2
minor channel
major channel

Volume Adjustment

This section describes how to adjust the volume. The mute function, which
turns the sound off and on, is also described.
Use [VOL. X / Y ] to adjust the audio volume.
or
• The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.
• The volume bar display will automatically disappear in
a few seconds.
Press [MUTE] to turn off and on the sound.
• "MUTE" is displayed on the TV screen for a few
seconds.
Press [MUTE] again or use [VOL. X / Y ] to recover the
original volume.
VOLUME 20
MUTE 20
15
EN