Mex VIN4MS Manual De Instalacion Y Uso & Mantenimiento página 31

Placa induccion 4 in
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 81
pressing [0] on the slider (left side).
Deactivation of an active timer
– A timer can be deactivated by setting the
value to 0.
– An independent timer can be deactivated
through the double activation of the power
key (1st TC active, 2nd TC and Timers
off).
Independent timer
– If the control unit is activated (the displays
of all hob zones show [0]), the independent
timer can be activated by pressing the
timer selection key. The display shows 0-
and is ready for setting the first digit of the
timer. By pressing the timer display, you
can go on to programming the second digit
of the timer. The timer is disconnected
after 10 seconds (blank display) if no
other settings are made. If a timer value
is set without the activation of a hob
zone within 10 seconds, the displays of
the hob zones are also disconnected).
The hot hob zones warning lights [H] are
permanently displayed.
– Until the timer is selected (the dot on the
display flashes for 10 seconds), it can be
set. The setting range is 0-99 minutes in
individual steps, for the Slider area.
– The countdown starts immediately after
the timer value has been set, starting
from the last set value.
– The timer is automatically deselected
after 10 seconds and the time display
indicates the timer value. Once the set
time has expired, an acoustic signal is
activated and the time display shows the
flashing symbol "00".
– The beep stops after 2 minutes and/or by
pressing any button. Subsequently, the
timer display will stop blinking and switch
off. Any hot cooking area warning lights
[H] are displayed permanently.
– By pressing the POWER key, the control
unit can be switched at any time from the
"sole timer function" to a hob zone, with or
without an active independent timer.
– If you switch the Touch Control back to
active mode with an independently active
timer, first select the independent timer
highlighted by the active selection "-"; in
this way you can reset it or change its
value. If you select a cooking area, the
"-" on the display disappears and the time
set on the independent timer is displayed.
If there is an independent timer set, you
cannot program a specific timer for a
cooking area. Once a hob zone has been
selected, the decimal point on the timer
display disappears and a decimal point
on the hob zone display flashes. When
the control unit is turned off by means of
the POWER key, the independent timer
(if functioning still) is also turned off.
Programming of the specific hob zone
timer
The power-on of the Touch Control enables
the timer setting for dedicated hob zones.
– If you activate a cooking area (cooking
area level > 0) and then select the timer
display (within 10 seconds), you can
assign a value of the timer to the cooking
area as a function of switching off the
cooking area. The LED corresponding to
the timer indicates the hob zone for which
the timer has been activated.
– As soon as the timer is selected, one
of the LEDs (9) corresponding to the
cooking area flashes and the timer shows
"0-" indicating that the first digit of the
timer can be programmed using the slider
area. Once you have set the first digit,
pressing the timer display allows you to
31
GB

Publicidad

Tabla de contenido
loading

Productos relacionados para Mex VIN4MS

Tabla de contenido