Mex VIN4MS Manual De Instalacion Y Uso & Mantenimiento página 32

set the second digit.
– When switching from one hob zone to
another, the timer display shows the
current timer value of the related hob
zone. The timer setting of the other hob
GB
zones remain active.
– The other settings are the same as those
for the independent timer.
– If more than one timer is active, the display
shows the value of the lowest timer (after
a deselection time of 10 seconds).
– After the set time has expired, an acoustic
signal is activated and the timer display
shows the flashing "00" symbol. The
LED of the corresponding timer flashes
at the same time. The cooking area
programmed turns off and the symbol
"0" is displayed fixed. The symbol "H" is
displayed after 10 seconds (deselection
time) in correspondence with a hot hob
zone ("hot"). Otherwise the symbol "0" is
displayed.
– The acoustic signal and flashing hob
zone LED stop after 2 minutes and/or
activating any key.
At this point the displays disappear and the
hob zone remains deselected.
The behaviour of the specific hob zone timer
is similar to that of the independent timer.
If a timer is programmed for a hob zone, the
limitation of the operating time depend on
the timer value and not on the value of the
standard table.
The precision of the timer value depends
on the precision of the clock μC that can
deviate by +/- 4% in 99 minutes.
PAUSE
Activation of the pause function
When at least one hob zone is functioning,
the heating elements can be deactivated by
pressing the Pause key.
The pause display has priority.
The timers that
programmed (also for the independent
timer) are stopped and do not function
during the pause time. The automatic heater
and booster are also deactivated on all the
hob zones during the activation, while the
calculation of the residual heat and the
limitation of the operating time continues to
function without being stopped.
The LEDs of the other functions (timer)
remain on depending on their status.
The pause can last up to 10 minutes. If it is
not terminated within this time interval, the
command is deactivated. The hob zone can
be switched at any time by means of the
On/Off key. Any active pause functions are
in this way terminated.
Termination of the Pause function
To terminate the Pause mode and start the
operation again, the Pause key and any
other key (not the same key again) must be
activated within 10 seconds.
In this way the function existing before the
Pause is re-established. If no other key is
activated within the 10 seconds, the hob
zone is also switched off.
Additional functions of the pause LED
The indicator light behaves in the following
way:
When the Pause function is deactivated, the
LED remains off. When the pause function
is activated, the LED remains on. The
LED flashes during the waiting time before
a second key is pressed. The LED also
flashes if the supplementary recall function
is possible after restart.
Recall (optional for the multifunction key)
The settings can be quickly recovered
after power-off by means of the power key,
the operator has 6 seconds to activate
the Pause key. This function can only be
performed if it was previously active and
was confirmed by an acoustic signal of the
32
have already been