Manuales relacionados para Next Level Racing F-GT
Resumen de contenidos para Next Level Racing F-GT
- Página 1 INSTRUCTION MANUAL FOR NEXT LEVEL RACING MATTE BLACK SIMULATOR COCKPIT If you require any support with your product or have an issue, please contact our friendly team at: support@nextlevelracing.com for a prompt response.
- Página 2 Thank-you for purchasing a Simulator Cockpit If you require any support with your product or have an issue, please contact our friendly team at: support@nextlevelracing.com for a prompt response. WARNING -Please do not use power tools for assembly as over tightening can damage your frame.
-
Página 3: What's In The Box
F-GT SIMULATOR COCKPIT What’s In The Box: LUMBAR/ NECK CUSHION SCREWS FOR WHEEL SHIFTER PEDALS 50MM BOLTS 60MM BOLTS SEAT BASE SEAT BACK For assistance please contact: support@nextlevelracing.com www.nextlevelracing.com... - Página 4 F-GT SIMULATOR COCKPIT Step 1: FRAME ASSEMBLY FLOOR POSTS SIDE FRAMES 1 X 16MM BOLT Repeat both sides Step 2: FRONT PLATE 2 X 50MM BOLTS Repeat both sides SUPPORT POST Step 3: 1 X 50MM BOLT. Repeat both sides.
- Página 5 F-GT SIMULATOR COCKPIT Step 4: SEAT ASSEMBLY 4 X 16MM BOLTS. Repeat both sides. SEAT SIDE FRAMES Attach SEAT SIDE FRAMES to SEAT BASE PLEASE NOTE: DUAL NUT PLATE SITS INSIDE SEAT SLIDER FRAME Step 5: Angle Mounts 2 X 16MM BOLTS.
- Página 6 F-GT SIMULATOR COCKPIT Step 7: Formula ASSEMBLY WARNING DO NOT OVER TIGHTEN 2 X 60MM BOLTS FOR PEDAL PLATE OR YOU CAN DAMAGE YOUR FRAME WHEEL PLATE 2 X 50MM BOLTS. Repeat both sides. 5. Attach PEDAL PLATE to the PEDAL ANGLE BAR using 2 X 16MM BOLTS on each side.
- Página 7 F-GT SIMULATOR COCKPIT Step 8: Formula ATTACHING SEAT 1 X 60MM BOLT. Repeat both sides. 1 X 60MM BOLT. Repeat both sides. Step 9: Formula TIPS - PEDAL ANGLE BAR: This determines the distance of your pedals. If you are a shorter user attach closer to the seat.
- Página 8 F-GT SIMULATOR COCKPIT Step 10: GT ASSEMBLY WARNING DO NOT OVER TIGHTEN 2 X 60MM BOLTS FOR PEDAL PLATE OR YOU CAN DAMAGE YOUR FRAME WHEEL PLATE 3. 2 X 50MM BOLTS. Repeat both sides. 5. Attach PEDAL PLATE to frame using 1 X 16MM BOLT.
- Página 9 F-GT SIMULATOR COCKPIT Step 11: GT SEAT ASSEMBLY 2 X 60MM BOLTS. Repeat both sides. 2 X 60MM BOLTS. Repeat both sides. Step 12: GT TIPS -In GT position for extra comfort you may find the LUMBAR SUPPORT CUSHION provided suitable to use for your higher back or shoulders.
- Página 10 F-GT SIMULATOR COCKPIT Step 13: GEAR SHIFTER ASSEMBLY 2 X 50MM BOLTS SHIFTER BRACKET SHIFTER ARM Left hand side shifter Step 14: 2 X 50MM BOLTS Right hand side shifter For assistance please contact: support@nextlevelracing.com www.nextlevelracing.com...
- Página 11 F-GT SIMULATOR COCKPIT Step 15: BUTTKICKER® GAMER 2 ADAPTOR 2 X 50MM BOLTS For assistance please contact: support@nextlevelracing.com www.nextlevelracing.com...
- Página 12 F-GT SIMULATOR COCKPIT Step 16: CHANGING FROM Formula TO GT 4. Wheel Angle May need adjustment 3. Seat Angle May need adjustment 1. PEDAL PLATE *Please note many GT users prefer pedals in Formula style position meaning no need for 2.
- Página 13 F-GT SIMULATOR COCKPIT Step 18 (OPTIONAL): For maximum rigidity over adjustability, install optional FELT STRIPS in WHEEL SUPPORT BARS. This means sliding holes in frame won't be effective to change position Step 19: Attach HEIGHT ADJUSTABLE FEET to bottom of cockpit frame For assistance please contact: support@nextlevelracing.com...
- Página 14 F-GT SIMULATOR COCKPIT NEED ASSISTANCE? If you require any support with your product or have an issue, please contact our friendly team at: support@nextlevelracing.com for a prompt response. For assistance please contact: support@nextlevelracing.com www.nextlevelracing.com...
- Página 15 F-GT SIMULATOR COCKPIT For assistance please contact: support@nextlevelracing.com www.nextlevelracing.com...
- Página 16 F-GT SIMULATOR COCKPIT UPOZORNĚNÍ - K montáži prosím nepoužívejte elektrické nástroje, protože nadměrné dotažení by mohlo poškodit rám. - Při montáži prosím mějte před každým šroubem umístěnou podložku dle níže uvedeného vyobrazení. Krok 1: Montáž rámu 1 X 16MM BOLT Opakujte na obou stranách...
- Página 17 F-GT SIMULATOR COCKPIT Krok 10: Montáž GT 2 X 60MM Bolts. Opakujte na obou stranách. *Až budete s nastavenou polohou spokojeni, dotáhněte co ne- jlépe, aby byla (delete this word) podpěra kola byla nehybná a pevná. Vložte WHEEL SUPPORT BARS. K nastavení výšky použijte 2 X 16MM BOLTS po obou stranách.
- Página 18 F-GT SIMULATOR COCKPIT WAARSCHUWING - Gebruik geen gereedschapsmiddelen voor montage, aangezien het te veel vastschroeven het frame kan beschadi- gen. -Tijdens deze montage moet u zeker een sluitring plaatsen vooraan elke bout zoals onderaan getoond. Stap 1: Frame-montage 1 X 16MM BOLT...
- Página 19 F-GT SIMULATOR COCKPIT Stap 10: GT Montage 2 X 60MM Bolts. Herhaal aan beide kanten. *Schroef zoveel mogelijk vast zodra u tevreden bent met de positie om ervoor te zorgen dat de wielsteun sterk en onbeweeglijk is. Voeg WHEEL SUPPORT BARS in. Gebruik de 2 X 16MM BOLTS aan elke kant om de hoogte aan te passen.
- Página 20 F-GT SIMULATOR COCKPIT AVERTISSEMENT -Νe pas utiliser d’outil électrique pendant le montage, car un serrage excessif peut endommager votre cadre/armature. -Lors du montage, assurez-vous d’avoir une rondelle placée entre chaque boulon et la pièce à serrer comme sur la photo ci-dessous.
- Página 21 F-GT SIMULATOR COCKPIT ble du siège. Faites le contraire si vous êtes plus grand(e). En position F1, pour plus de confort, vous pouvez vous servir du LUMBAR SUPPORT CUSHION fourni et qui est idéal pour soutenir votre cou ou votre tête.
- Página 22 F-GT SIMULATOR COCKPIT ATTENZIONE -Si prega di non utilizzare strumenti elettrici per l’assemblaggio in quanto un fissaggio troppo stretto potrebbe dannegg- iare il telaio. -Durante l’assemblaggio, assicurarsi di fissare la rondella su ogni vite come mostrato in figura. Passaggio 1: Assemblaggio del telaio...
- Página 23 F-GT SIMULATOR COCKPIT Passaggio 10: Assemblaggio per GT 2 X 60MM Bolts. Ripetere su entrambi i lati. * Una volta fissata la posizione desiderata, stringere saldamente per una migliore tenuta. Inserire le WHEEL SUPPORT BARS. Utilizzare le 2 X 16MM BOLTS su ogni lato per regolare l’altezza.
- Página 24 F-GT SIMULATOR COCKPIT ADVERTENCIA -No utilice herramientas eléctricas para montarlo, ya que apretarlo demasiado puede dañar la estructura. -Durante el montaje, asegúrese de colocar una arandela delante de cada tornillo como se muestra en la imagen sigui- ente. Paso 1: Montaje de la estructura 1 X 16MM BOLT.
- Página 25 F-GT SIMULATOR COCKPIT cuello o la cabeza. Paso 10: Conjunto de GT 2 X 60MM Bolts. Repita en ambos lados. Cuando esté satisfecho con la posición, apriételos todo lo posible para garantizar que el soporte del volante sea fuerte y rígido.
- Página 26 F-GT SIMULATOR COCKPIT WARNUNG -Bitte verwenden Sie keine Elektrowerkzeuge für die Montage, da zu festes Verschrauben den Rahmen beschädigen kann. - Bei der Montage ist darauf zu achten, dass sich eine Unterlegscheibe an der Vorderseite jedes Bolzens befindet, so wie unten abgebildet.
- Página 27 F-GT SIMULATOR COCKPIT In F1 Positionen finden Sie für zusätzlichen Komfort die LUMBAR SUPPORT CUSHION für den Nacken oder Kopf. Schritt 10: GT Montage 2 X 60MM Bolts. Auf beiden Seiten wiederholen. *Sobald Sie mit der Position zufrieden sind, ziehen Sie es so fest wie möglich an, um sicherzustellen, dass die Radhalterung starr und fest ist.
- Página 28 ACCESSORIES FLOOR MAT F-GT MONITOR STAND LOCKABLE WHEEL CASTORS For assistance please contact: support@nextlevelracing.com www.nextlevelracing.com...
- Página 29 SHOP THE RANGE WHEEL STAND LITE WHEEL STAND FLIGHT STAND GTULTIMATE COCKPIT FLIGHT COCKPIT GTTRACK COCKPIT MOTION PLATFORM V3 F-GT COCKPIT For assistance please contact: support@nextlevelracing.com www.nextlevelracing.com...
- Página 30 For assistance please contact: support@nextlevelracing.com...