SodaStream SOURCE Manual De Instrucciones página 11

Ocultar thumbs Ver también para SOURCE:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

You might be out of gas; replace your carbonator.
Check that carbonating bottle has been filled up with water to the fill line.
Ensure that the Soda Maker is always in the upright position.
Carbonator may be loose. DO NOT use tools. Detach the bottle, open the rear cover,
and retighten the carbonator. Apply firm pressure but do not over tighten. If the
carbonator is already firmly in place, it may be empty. Replace with a full carbonator.
WARNING: Use caution when removing carbonator as it may be very cold.
CANNOT PULL BOTTLE LOADER TAB:
Make sure carbonating block is in its fully upward position.
Pull bottle loader tab firmly towards you.
Make sure the carbonating block is in its fully upward position.
Pull the bottle loader tab toward you until it clicks
Insert bottle into Snap-Lock
Firmly push bottle up and back until it locks.
CANNOT GET THE BOTTLE OUT:
Make sure the carbonating block is in its fully upward position.
Pull the bottle toward you.

Publicidad

Tabla de contenido
loading

Productos relacionados para SodaStream SOURCE

Tabla de contenido