V2 Zariss Manual Del Usuario página 71

t.LUC
the relay is enabled at the receiving of a control of start or pedestrian start; choosing this option, a submenu is entered - it allows
no
to set the length of the activation of the relay from 0.0" to 20'0 (default 1'00). At the time limit, the relay is disabled.
CiCL
the relay of the courtesy lights is not automatically activated
the relay is activated during the motion of the gate; when the gate stops (closed or open) the relay is on all the time
LP.PA
(set in the submenu
If the option is activated, the relay is on also during the pause time
t.LUC
).
Pause after transit
In order to let the gate open for the shortest possible time, it is possible
to stop the gate once the passage before the photocells is detected. If
the automatic working is enabled, the time of the pause is
If interior and exterior photocells are installed, the gate only pauses after
passing in front of both has been detected.
Courtesy lights
This menu allows setting the automatic operating
of the courtesy lights during the opening cycle of
the gate.
NOTE: If the output is used to drive a flashing
light (with internal flasher) select
Auxiliary channel
This menu allows setting the operating of the relay of the lighting of the
courtesy lights by means of a remote control stored on the channel 4 of
the receiver.
Mon
the relay is activated for all the length of the transmission of
the remote control. Releasing the key of the remote control the
relay is deactivated
tiM
the relay is activated receiving the transmission of the remote
control; it is disabled after the time set for the parameter
LUCi
inside the menu
biSt
the status of the relay changes at each transmission of
the remote control
69
Ch.tr
.
CiCL
.
t.LUC
long
t.LUC