End Of Programming Procedures; Default Settings Reset; Exiting Without Savings; Changes Confirmation - Hiltron security XR Serie Manual Para El Usuario

security
3.1.5

End of Programming Procedures

LED lit
LED blinking
In this mode, "SIRENE" (Sirens) LED is lit, "ALLARME" (Alarm) LED blinks and
"CONTROLLO ZONE" (Zones Status Control) Zones 3 and 4 LEDs blinks.

3.1.5.1 Default Settings Reset

Pressing "ESCLUSIONE" (Exclusion) Zones 3 and 4 LEDs turn off,
and Zone 1 and 2 LEDs are lit; whenever you press these 2 buttons, the
Central Unit utters a "BEEP".
When the 2 buttons are released, the Central Unit utters another
"BEEP" and the following settings are resetted:
- Exiting Time:
- Entering Time:
- Alarm Time:
- Entering/Exiting Time acoustic signalling:
- Main Power Supply Absence Alarm on enabled system:
- RF Channel Sabotage acoustic signalling:
- Acoustic Signalling in case of main power supply absence on enabled system
and anomaly of the Sensors and Sirens power supplier:
- System Code will
At the end, the Central Unit exits automatically this mode and
"ALLARME" (Alarm) LED turn off.

3.1.5.2 Exiting Without Savings.

Press "ESCLUSIONE" (Exclusion) Zone 3 to exit the Central Unit
programming without savings. "ALLARME" (Alarm) LED turn off.

3.1.5.3 Changes Confirmation

Press "ESCLUSIONE" (Exclusion) Zone 4 button to exit from
programming mode saving all changes. "ALLARME" (Alarm) LED turns
off.
Press "MEMORIA ALLARME" (Alarm Memory) to return to the first programming function:
RF Channel Test .
antifurtoriginale.it
ST/BY
RETE
POWER
ASSENZA RETE MAIN POWER
INSERITO
ARMED
ALLARME
ALARM
FLASH:
MEMORIA ALLARME
MEMORY ALARM
XR500
be unchanged.
24h
CENTRALE
CENTRAL
SENSORI
STATO ZONE
SENSORS
ZONE STATE
SIRENE
SIRENS
RX / TX
MEMORIA
ALLARME
ALARM
MEMORY
Programming
ZONE CONTROL
ON FLASH
ZONA APERTA ZONA ESCLUSA
ZONE ESCLUSED
ZONE OPENED
OFF LAMP: ZONA
ZONA CHIUSA ALLARMATA Zone alarmed
CLOSED ZONE
E X C L U S I O N
180 seconds (3 minutes)
3 seconds
4 seconds
enabled
desabled
desabled
desabled
41