Care And Maintenance - Scott Living 1214WF-40-233 Instrucciones De Ensamblaje, Cuidado Y Uso

CARE AND MAINTENANCE

• Make sure the unit is turned OFF, unplugged and the heating elements of heater are cool whenever you
are cleaning the heater.
• Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or household
cleaners as these products will damage the metal trim.
• The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing
life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater and air
intake/output vents is recommended.
• Any other servicing should be performed by an authorized service representative.
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or
rewiring of this unit should be carried out by a licensed electrician in accordance with national
and local codes.
If repairing or replacing and electrical component or wiring, the original wire routing, color
coding and securing locations must be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable
regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a
qualified service technician to inspect te fireplace and replace any part of the electrical system.
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the
risk of fire, electrical shock or personal injury.
WARNING: During any service of this appliance, the power to the unit must be turned off. First
turn the main power switch to the "OFF" position. Then remove the electrical plug from the wall
outlet.
Note: When the fireplace is not in use, the fireplace should be stored in a dry location, away from
possible damage. The power cord should be stored properly to avoid contact with hot or sharp objects.
Replacing the Remote Control Batteries
When the remote control (E) stops operating or its
range seems reduced, it is time to replace the
batteries. Note: The batteries should be removed if the
product is to be left unused for a long time.
1. The battery compartment is located on the back
of the remote control (E).
2. Remove battery cover from the back of remote
control (E) and remove the old batteries.
3. Insert 2pcs AAA batteries, ensuring the polarities of
the battery match the inside of the battery compartment.
4. Re-insert the battery door.
Note:
Do not mix old and new batteries.
Do not mix alkaline, standard (carbonzinc), or rechargeable (nicad, nimh, etc) batteries.
Non-rechargeable batteries are not to be recharged. Exhausted batteries are to be removed from
the product.
Harmful if swallowed.
13
E