Medistrom Pilot-12 Plus Manual Del Usuario página 7

included with the Pilot-24 Plus. It is provided with the ResMed S9™
PAP device) plug the Connector Tip (D) into the ResMed S9™ Original
Power Adapter. Plug the other end of the Connector Tip (D) into the
battery's CHARGE port. Ensure that the other end of the ResMed
S9™ Original Power Adapter is plugged in to the mains power outlet.
Please note: The battery can be charged regardless of which way the
OFF/ON switch is toggled. If the battery is charging properly, the
four green charge indicator LEDs (3c) will flash, and will light up solid
green once it is fully charged.
2. OFF/ON SWITCH: This switch allows the battery to be turned ON
for usage and turned OFF for storage. When the battery is switched
to the ON position, a blue OFF/ON indicator LED (2a) will turn on
above the switch. When the battery is switched to the OFF position,
the OFF/ON indicator light (2a) will NOT light up. IMPORTANT!
Please remember to toggle this switch to the ON position before
using the battery with the PAP device. Remember to turn the switch
to OFF position before storing the battery. CAUTION! FULLY CHARGE
BATTERY BEFORE STORAGE AND EVERY 6 MONTHS AFTERWARD!
3. CHARGE LEVEL INDICATOR: By pressing the charge level indicator
button (3a) the charge level of the battery can be checked. The
green LED (3c) will light up for 4 seconds showing the battery charge
level while the battery is powering your PAP device. If 4 charge
indicator lights (3c) are lit green, then the battery is fully charged.
Please refer to the LO to HI charge level indicator image (3d) to
determine the remaining power level. When the battery is charging,
the charge indicator LEDs (3c) will light up in sequence until the
charge reaches each level. When the battery is plugged into the
charger, but is already fully charged, then all charge indicator lights
are lit solid green. Warning Indication: Once CPAP battery is fully
discharged, the orange warning light (3b) will flash, and the sound
alarm will beep. Discontinue using your PAP device and charge the
battery as soon as possible.
4. USB PORT: This port can be used to power and charge most
electronic hand-held devices.
7