I.SOUND DuraTunes Guía De Usuario página 5

2. Plug the Micro-USB end of the cable into the Micro-USB
charge port labeled [ ] located within the closed rubberized
door.
3. The LED indicator light located next to the phone/Bluetooth
bu on will turn orange. Once the speaker is fully charged, the
LED indicator light will turn o .
NOTE: When the ba ery level is below 20%, you will hear a
voice saying "Ba ery Level Low", and the volume will lower
automatically to conserve ba ery. Charge your DuraTunes
with the included charge cable.
Connecting via Bluetooth® ( rst time set-up)
1. Press and hold the power bu on located on the side of the
speaker. You will hear a voice say "Bluetooth mode" and the
LED indicator light will rapidly ash blue.
2. Open the se ings on your Bluetooth device (Bluetooth must
be enabled).
3. Select DuraTunes om the devices list.
4. Once paired, a voice will say "Bluetooth paired" and the
Bluetooth LED will become solid blue.
5. Volume can be adjusted om your device.
NOTE: Your device will automatically nd and pair with the
DuraTunes a er the initial pairing. If your device does not
automatically pair, turn o the speaker and repeat steps 1-4.
Connecting via audio cable
1. Press and hold the power bu on located on the side of the
speaker. You will hear a voice say "Bluetooth mode" and the
LED indicator light will rapidly ash blue.
2. Insert one end of the included audio cable into the AUX port
on the side of the speaker. A voice will say "AUX in mode".