Features; Front And Right Side - Insignia NS-LCD42HD Guia Del Usuario

Insignia NS-LCD42HD 42" LCD HD 1080p TV
Outdoor antenna grounding
If an outside antenna or cable system is
connected to your TV, make sure that the
antenna or cable system is grounded to provide
some protection against voltage surges and
built-up static charges. Article 810 of the
National Electrical Code, ANSI/NFPA No. 70,
provides information with respect to correct
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of the antenna-discharge unit,
connection to grounding electrodes, and
requirements for the grounding electrode.
1
1 Electric service equipment
Power service grounding electrode
2
system
3 Ground clamps
4 Grounding conductors
Antenna discharge unit
5
6 Grounding clamp
7 Antenna lead-in wire
Note to CATV system installer
This reminder is provided to call the CATV
system installer's attention to Article 820-40 of
the NEC that provides guidelines for correct
grounding and in particular, specifies that the
cable ground must be connected to the
grounding system of the building as close to the
point of cable entry as practical.
Mobile telephone warning
To avoid interference with your TV picture and
sound, operating problems, or even damage,
keep your mobile telephone away from the TV.
End of life directives
Your new TV contains materials which can be
recycled and reused. At the end of your TV's life,
specialized companies can dismantle the
discarded TV to concentrate the reusable
materials and to minimize the amount of
materials to be disposed of. Make sure that you
dispose of your old TV according to local
regulations.

Features

Front and right side

7
6
5
4
3
2
#
1
2
3
4
5
www.insignia-products.com
1
Feature Description
POWER button Press to turn your TV on or put it into
Standby mode.
VOL +/VOL – Press to increase or decrease the volume.
buttons In Menu mode, function as the right and
left arrows (respectively) to go to the next
or previous menu, or increase or decrease
a setting.
Press to go to the next higher or next
CH /CH
lower channel. In Menu mode, function as
buttons
the up and down arrows (respectively).
MENU button Press to show the on-screen menu.
INPUT button Press to cycle through the available input
sources. Sources include:
• TV (cable/air)
• VIDEO1 (side)
• VIDEO2 (back)
• VIDEO3 (S-Video)
• VIDEO4 (YPbPr1)
• VIDEO5 (YPbPr2)
• VIDEO6 (HDMI)
• VIDEO7 (HDMI2)
• COMPUTER (VGA)
2
3
4
5
6
7
8
3