How To Use; Remote Control - Vornado 5303DC Manual Del Usario

HOW TO USE

1. Touch to power on.
Your circulator returns to last saved
memory setting.
-/+
2. Select desired speed by pressing .
-/+
Press and hold to adjust speed up
or down in 5 speed increments. Speed is
indicated by number shown on Speed/
Timer Indicator Display.
3. Press to activate timer. The
illuminates and Speed/Timer Indicator
0
Display flashes to indicate Timer
Adjustment Mode. While in this mode,
select amount of time in one-hour
intervals by pressing -/+. After three
seconds, flashing stops and display shows
hours to indicate timer is set. The display
returns to the last speed selected. Touch
to quickly tell how many hours are
remaining on the timer.
10 English

REMOTE CONTROL

Screwdriver required.
4. To adjust timer, repeat Step Three. Your circulator remote includes (1) coin style 3V CR2032 battery. Battery comes pre-installed. Remove battery pull tab before first use.
5. To cancel timer, repeat Step Three and
0
set timer for .
1. For battery replacement, the remote
CORD MANAGEMENT
1. Wrap cord around Air Accelerator,
located on back of unit. Secure cord with
2. To replace battery, open battery door on
three clips located at 2, 6 and 10 o'clock
positions.
Note: Remove battery from the remote
control when not in use for an extended
period of time and always remove dead
battery immediately and replace with fresh.
Do not store dead battery in remote.
requires one coin style 3V CR2032 battery.
Always use the correct size and grade of
battery for this product.
the back side of the remote control (you
will need to loosen the small screw on
door using a #1 Phillips screwdriver). If
necessary, clean the battery contacts and
also those of the device prior to battery
installation. Remove any plastic protection
from the battery and place it in the
+
remote with the side facing out. Ensure
the battery is installed correctly with
regard to polarity. Replace the battery
door and screw.
The remote control functions are the same as
the control panel on the circulator.
The remote requires a line-of-sight path to
POWER
allow for the signal to be received by the
circulator. Point the remote control at the
SPEED/TIMER
display panel for best reception.
ADJUSTMENT -/+
TIMER
English
11