Ryobi RPH26E Manual De Utilización página 16

FUEL AND REFUELING
HANDLING THE FUEL SAFELY
flames. Do not inhale fuel vapors.
see a doctor immediately.
Clean up spilled petrol immediately.
MIXING THE FUEL (Fig. 3)
requires pre-mixing petrol and 2-stroke oil. Pre-mix
unleaded petrol and 2-stroke engine oil in a clean
container approved for petrol.
This engine is certified to operate on unleaded petrol
of 91 ([R + M] / 2) or higher.
Do not use any type of pre-mixed petrol / oil from fuel
service stations, this includes the pre-mixed petrol / oil
intended for use in mopeds, motorcycles, etc.
Use synthetic 2-stroke oil only. Do not use automotive
oil or 2-stroke outboard oil.
Mix 2% synthetic 2-stroke oil into the petrol. This is
a 50:1 ratio.
Mix the fuel thoroughly and also each time before
fueling.
Mix in small quantities. Do not mix quantities larger
containing a fuel stabilizer is recommended.
1 Litre + 20 ml
2 Litres + 40 ml
3 Litres + 60 ml
4 Litres + 80 ml
5 Litres + 100 ml
FILLING THE TANK
Clean surface around the fuel cap to prevent
contamination.
keep fuel from escaping around the cap.
Carefully pour fuel mixture into the tank. Avoid spillage.
Prior to replacing the fuel cap, clean and inspect
the gasket.
English (Original instructions)
NOTE:
engine during and after first use.
STARTING AND STOPPING (Fig. 4)
To start a cold engine:
1. Press the primer bulb 10 times.
3. Keeping the throttle trigger squeezed completely and
5. Pull the starter grip until the engine starts. Do not pull
To start a warm engine:
1. Press the primer bulb 10 times.
=
=
= 50:1 (2%)
To stop the engine:
=
=
the engine stops.
MAINTENANCE
14
Immediately replace and tighten the fuel cap.
fueling site before starting the engine.
WARNING
Move at least 9 m from the refueling site before
starting the engine. Do not smoke.
WARNING
Never start or run the engine inside a closed or
poorly ventilated area; breathing exhaust fumes
can kill.
position before trying to start unit.
NOTE: After the 7th press, the fuel should be visible
in the primer bulb. If not, continue pressing until the
fuel is visible.
choke position.
pull the starter grip until the engine attempts to start.
Do not pull the starter grip more than 4 times.
choke position.
the starter grip more than 6 times.
NOTE: If the engine does not start, repeat the
procedure from step 2.
choke lever to position.
position.
starter grip until the engine starts.
WARNING
Use only original manufacturer's replacement
parts, accessories and attachments. Failure
to do so can cause possible injury, poor
The cutting attachment must not rotate in idle mode.
I" (RUN)
O " position until