Ryobi RPH26E Manual De Utilización página 18

If these solutions do not solve the problem, contact your authorised service dealer.
PROBLEM
not idle long enough to
engage throttle
Engine does not stop
accelerate.
only run at high speed
at half choke.
Engine does not reach
full speed and emits
excessive smoke.
English (Original instructions)
TROUBLESHOOTING
POSSIBLE CAUSE
2. No spark.
3. No fuel.
4. Engine is flooded.
6. Old fuel.
Temperature can effect engine idle
time and rpm.
Electrical connection is loose/
unplugged
Engine requires approximately
Carburetor requires adjustment.
1. Check oil fuel mixture.
2. Air filter is dirty.
dirty.
SOLUTION
2. The spark plug may be damaged, remove it and check
3. Push primer bulb until bulb is full of fuel. If bulb does
not fill, primary fuel delivery system is blocked. Contact
a servicing dealer. If primer bulb fills, engine may be
flooded, proceed to next item.
4. Remove spark plug, turn unit so spark plug hole is aimed
product. Clean and reinstall spark plug. Clean up any
does not start, set choke lever to
normal starting procedure. If engine still fails to start,
5. Contact a servicing dealer.
Fuel over 30 days old may prevent the unit from
starting.
Flip choke lever to position and pull starter until engine
starts.
stop using the product. Check electrical connection on the
bottom of the unit and make sure it is properly connected.
Contact servicing dealer if the problem persists.
accelerate after three minutes, contact a servicing dealer.
Contact a servicing dealer.
1. Use fresh fuel and the correct 2-stroke oil mix.
2. Clean air filter. Refer to "Cleaning the air filter screen"
earlier in this manual.
3. Contact a servicing dealer.
16
I" position.
position and pull
. If engine
position and repeat
to stop the engine. Immediately