Audio Pro SUB Evidence MkII Manual De Instrucciones página 7

INSTRUCTIONS
Congratulations to your choise of Audio Pro subwoofer and to a new sound experience.
Audio Pro subwoofer is a unique product built with advanced technique. It is very easy to
handle and install. It is equipped with the unique Audio Pro ace-bass technique that in combination
with the built-in amplifier, the long throw woofer and the extremely solid cabinet offers a natural
and deep bass reproduction at sound levels you never thought existed.
The Audio Pro subwoofer offers extraordinary performance and lots of possibilities. In order
to get the most out of your new subwoofer, we recommend you to spend time and carefully read
these instructions before you connect and start up your system.
What is ace-bass ?
Normally, speaker design is bound to follow the laws of physics. The consequence will be, to get
deep bass, the speakerbox must be very large. With the ace-bass technique we can "change"
the laws of physics in the way that the driver believes it is placed in a much larger speaker box.
Furthermore, the ace-bass technology improves the driver performance. With the ace-bass
technique, we can design smaller subwoofers with deeper and cleaner bass.
1. UNPACKING
Carefully unpack the Audio Pro subwoofer and check for any damages. If possible, keep the cartonbox if future
transportation is needed.
You should immediately contact your dealer if the subwoofer is damaged .
2. INSTALLATION
There are different methods to connect your subwoo-
fer to a HiFi / Home Theater system. In the following
we explain 2 different ways. NOTE! Do not connect
the mains cord until all other installation is
completed.
2.1 To an amplifier / pre-amplifier with
Subwoofer-out terminal.
Connect the enclosed cord from your amplifiers sub-
woofer-out terminal to LINE IN on the subwoofer. (Also
use the enclosed Y adaptor for L and R inputs)
The audio signal is passing through the cord from the
subwoofer-out terminal to the built-in amplifier. By using
the LOWPASS control, the upper frequnency of the
subwoofer can be variably selected from 50Hz - 100
Hz.
Note:
Connect the satellite speakers to the main amplifier
speaker terminals.
All manuals and user guides at all-guides.com
2.2 To Speaker output terminal
Connect speaker cables from the speaker terminals of
your amplifier to the Speaker Level input of the sub-
woofer. Carefully check the polarity of the cables (+ to +
and - to -). Connect both Left and Right channels. The
satellite speakers are connected to SPEAKER OUTPUT
on the subwoofer. Again, carefully check the polarity
(+ to + etc).
In this installation, the satellite speakers HIPASS cross-
over frequency is automatically set to 100 Hz. If you
want the speakers to perform full frequency range,
connect them to the main amplifier Speaker Output.
7
(High level)
English