LOCATING THE PROGRAMMING BUTTON
1. Position pistol box in front of you with door open.
2. Reach hand inside the box and behind key pad to
fi nd the smooth, hard panel.
3. The programming button will be small and hard. It
is located on the center of the panel close to the
wall of the safe.
5. Red light will fl ash when button is pressed.
For further assistance, please call 1-800-874-6625.
PROGRAMMING STEPS
1. Enter the manufacturer's code to open the door.
2. Push upper left hand corner of door after
entering code.
3. Press and hold programming button until green
light stays on.
4. Enter your new user code. We recommend 4-5
digits. The green light will fl ash with each entry.
3. After inputting new user code, press and hold
programming button again until green light turns
off and solid red light comes on. Then release the
button. Red light will stay on.
4. Enter new user code again for confi rmation. The
green light will fl ash with each entry.
5. Press and hold programming button again until
green light fl ashes. If red light fl ashes, start over
at step one.
Green light turns off
Red light stays on
- 3 -