Led Light - Indication; Installing Your Unit - Homak HS10036683 Guía De Utilización Y Directivas De Funcionamiento

Aja rápida de la pistola del acceso
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

LED LIGHT - INDICATION

Green light with each
correct key press
Red light with each key
press
Solid green light after
entire code is entered
Flashing red light after
programmed personal
code is entered
Flashing green and red
light together

INSTALLING YOUR UNIT

CAUTION: You must mount your Homak quick access pistol box to a
stationary object before use.
1. Locate the (4) bolts, (4) nuts, and (2) lag screws.
2. Place the pistol box in a suitable location. Using the screws provided
with the washers, locate and fasten the box to a wall stud.
*Multiple units of the same size (HS10036685) may be
purchased to be attached together.
Multiple Unit Attachment Holes
(HS10036685 only)
Top View
3. Mounting hole locations vary with different models.
Ready for code
Lockout for 15 minutes. This occurs after
entering three consecutive wrong codes
Code is correct - Open unit by pressing on
upper left hand corner of door while green
light is lit solid
Code was unsuccessfully programmed or
code is incorrect
Battery power is insuffi cient or there is a
bad connection. Please refer to 9-Volt
battery backup
Bottom View
- 4 -
Mounting Holes
Back/Side View

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hs10036684Hs10036685

Tabla de contenido