LG WT19SB Serie Manual Del Propietário página 75

Symptoms
Control panel has powered off
due to inactivity.
Washing machine is
unplugged.
Water supply is turned off.
Controls are not set properly.
Door is open.
Circuit breaker/fuse is tripped/
blown.
Washing
Control needs to be reset.
machine will not
operate
INICIO/PAUSA (START/PAUSE)
was not pressed after a cycle
was set.
Extremely low water pressure.
Washing machine is too cold.
Washing machine is heating
the water or making steam.
Reason Solution
• This is normal. Press the
ENCENDIDO/APAGADO (POWER) button to
turn the washing machine on.
• Make sure cord is plugged securely into a
working outlet.
• Turn both hot and cold taps fully on.
• Make sure the cycle was set correctly,
close the door and press the
INICIO/PAUSA (START/PAUSE) button.
• Close the door and make sure that nothing
is caught under the door preventing it from
closing completely.
• Check house circuit breakers/fuses. Replace
fuses or reset breaker. The washing machine
should be on a dedicated branch circuit. The
washing machine will resume the cycle where it
stopped once power is restored.
• Press the ENCENDIDO/APAGADO (POWER)
button, then reselect the desired cycle and
press the INICIO/PAUSA (START/PAUSE)
button.
• Press the ENCENDIDO/APAGADO (POWER)
button then reselect the desired cycle and
press the INICIO/PAUSA (START/PAUSE)
button. The washing machine will shut off if the
INICIO/PAUSA (START/PAUSE) button is not
pressed within 60 minutes.
• Check another tap in the house to make sure
that household water pressure is adequate.
• If the washing machine has been
exposed to temperatures below freezing
for an extended period of time, allow
it to warm up before pressing the
ENCENDIDO/APAGADO (POWER) button.
• The washing machine drum may stop operating
temporarily during certain cycles, while water is
safely heated to a set temperature.
EN
35