LG WT19SB Serie Manual Del Propietário página 76

Symptoms
Filter clogged.
Supply hoses may be kinked.
Washing
machine not
filling properly
Insufficient water supply.
Hot and cold supply hoses are
reversed.
Kinked drain hose.
Washing
machine will not
Drain located higher than 1.2
drain water
m above the floor.
Washing machine not
unloaded promptly.
Wrinkling Washing machine overloaded.
Hot and cold water supply
hoses are reversed.
Incomplete or
no dispensing of Too much detergent used.
detergent
Musty or
Inside of drum was not
mildewy odor in
cleaned properly.
washing machine
The load is too small.
Cycle time is Heavy articles are mixed with
longer than usual lighter items.
The load is out of balance.
36
Reason Solution
• Make sure the inlet filters on the fill valves are
not clogged.
• Check that supply hoses are not kinked or
clogged.
• Make sure that both hot and cold water taps
are turned on all the way.
• Check supply hose connections.
• Ensure that the drain hose is not kinked.
• Make sure that the drain hose is no higher
than 1.2 m above the bottom of the washing
machine.
• Always remove items from the washing
machine as soon as the cycle is complete.
• The washing machine can be fully loaded, but
the drum should not be tightly packed with
items. The door of the washing machine should
close easily.
• Hot water rinse can set wrinkles in garments.
Check the supply hose connections.
• Follow the guidelines provided by the detergent
manufacturer.
• Run the Limpieza de Tina (Tub Clean)
programme regularly.
• Add more items to allow the washing machine
to balance the loads.
• Always try to wash articles of somewhat similar
weight to allow the washing machine to evenly
distribute the weight of the load for spinning.
• Manually redistribute the load if articles have
become tangled.
EN