Configure User Settings; Set Up Personal Information; Configure Watch Settings - Ironman TIMEX V.16 Manual Del Usario

seT uP weIghT unITs
Weight units determine whether your weight is measured in pounds (LB) or kilograms (KG).
1. Press UP or DOWN to select WEIGHT, and then press SELECT.
2. Press UP or DOWN to select LB or KG, and then press SELECT. A check mark displays.
3. Press DONE.
seT uP heIghT unITs
Height units determine whether your height is measured in inches (IN) or centimeters (CM).
1. Press DOWN to select HEIGHT, and then press SELECT.
2. Press UP or DOWN to select IN or CM, and then press SELECT. A check mark displays.
3. Press DONE.

ConfIgure user seTTIngs

seT uP Personal InforMaTIon

Enter your personal information to ensure accurate calculations during workouts.
1. Press MODE until CONFIGURE displays.
2. Press DOWN to select USER, and then press SELECT. The USER menu opens.
3. Press UP or DOWN to select the setting to change, and then press SELECT. The SETTING menu opens.
4. Change the values to match your personal data.
• Press UP or DOWN to change a numerical value, and press NEXT to move to the next value. Press DONE
to go back to the USER menu.
• Press UP or DOWN to select a non-numerical value, and then press SELECT to apply the check mark.
Press BACK to go back to the USER menu.
5. Repeat for Birthday, Gender, Weight, Height, and Activity.
BIRTHDAY Set the month, day, and year of your birth.
GENDER Select MALE or FEMALE.
WEIGHT Enter your weight (in LB or KG, depending on your UNITS settings)
HEIGHT Enter your height (in IN or CM, depending on your UNITS settings)
ACTIVITY Select a level and type for the activity you will participate in the most.
noTe: A Brick workout is comprised of two or more sports disciplines (usually bike followed by run) and
performed back-to-back when used to train multisport athletes.

ConfIgure waTCh seTTIngs

The watch configuration provides you the option to set the button beep, hourly chime, zone alert, and GPS
time synchronization.
1. Press MODE until CONFIGURE displays.
2. Press DOWN to select WATCH, and then press SELECT.
seT uP buTTon beeP
Set whether the watch will beep when a button is pressed. Pressing the INDIGLO
watch beep.
1. Press SELECT to open BUTTON menu.
2. Press UP or DOWN to select BEEP OFF or BEEP ON, and then press SELECT. A check mark displays.
3. Press DONE.
seT uP hourlY ChIMe
Set whether the watch will chime at the top of every hour.
1. Press UP or DOWN to select HOURLY, and then press SELECT.
2. Press UP or DOWN to select CHIME OFF or CHIME ON, and then press SELECT. A check mark displays.
3. Press DONE. The N icon displays in the status bar in Time of Day mode.
button will not make the
®
25