Before First Use; Removing The Insulation Strips; Operation; Inserting/Replacing The Batteries - Miomare HG01030A Instrucciones De Utilización Y De Seguridad

Dispensador de jabón con sensor
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Risk of equipment damage
Only use the specified bat-
tery type!
When inserting the battery
ensure the correct polarity!
This is shown in the battery
compartment!
If necessary, clean the bat-
tery and de vice contacts
before inserting the battery!
Remove dead batteries from
the device immediately!

Before first use

Removing the
insulation strips
Note: The product is supplied
with the batteries already in place.
Remove the insulating stripes
from the battery compartment
before first use.
6
36 GB/MT

Operation

 
Inserting/replacing
 
the batteries
 
M ake sure the soap con-
tainer
is empty and the
3
ON / OFF switch
"OFF"-Position.
 
O pen the battery compart-
ment
(see Fig. B).
6
 
I nsert four 1.5 V
(AAA) (included) into the
battery compartment
(see Fig. C).
Note: Make sure you fit the
batteries the right way round
(polarity). The correct polar-
ity is shown inside the battery
compartment
 
T hen close the battery com-
partment
again.
6
Filling the container
 
with soap
Make sure the soap con-
tainer
is empty and the
3
at
5
batteries
6
.
6

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hg01030c

Tabla de contenido