Connecting The Power Supply; Running The Setup Wizard - Marmitek IP ROBOCAM 8 Instalación Rápida

CONNECT THE ANTENNA
Attach the included external antenna to the back of the camera.

CONNECTING THE POWER SUPPLY

Attach the external power supply to the DC power input
connector located on camera's rear panel, and then connect
it to your local power supply.
TIP: You can check if power is supplied when the
Power LED on the camera is illuminated.

RUNNING THE SETUP WIZARD

The Setup Wizard is a convenient tool that will guide you through the installation of your camera easily and quickly.
After connecting the camera to your computer, you can install the Setup Wizard and complete the configuration
now.
1. Insert the Installation CD-ROM into your CD-ROM drive.
Click Install Wizard.
2. Click Next.
3. Click Yes.
4. Click Next.
4 MARMITEK