Marmitek IP ROBOCAM 8 Instalación Rápida página 6

CHANGING THE ADMIN ID AND PASSWORD
By default settings, the Admin ID and Password are blank. For security purpose, you are recommended to change
the Admin ID and Password immediately.
Click Wizard. The dialog box as shown appears,
asking you to enter the Admin ID and Password.
Click OK.
If required, select the Change options and enter
the new Admin ID and Password.
Click Next.
The settings of IP Address, Subnet Mask and
Default Gateway must correspond with your
camera and networking settings.
Please check with your network administrator
for correct settings.
Click Next.
The Connection Mode depends on how your camera is
connected to your network. Click Infrastructure for use with a
router or Adhoc for peer-to- peer. The Network Name, Wireless
Channel, and Encryption Key MUST correspond with your wire-
less network settings.
This window displays the settings you set up. For any change,
click Back to modify your settings. Otherwise, click Restart
to save and apply the settings.
6 MARMITEK