Safety Warnings; Installation Procedure - Marmitek PROGUARD800 Serie Manual Del Usario

SAFETY WARNINGS

• To prevent short circuits, this product should only be used inside and only in dry
spaces. Do not expose the components to rain or moisture. Do not use the product
close to a bath, swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures
or bright light sources.
• In case of improper usage or if you have altered and repaired the product
yourself, all guarantees expire. Marmitek does not accept responsibility in the case
of improper usage of the product or when the product is used for purposes other
than specified. Marmitek does not accept responsibility for additional damage other
than covered by the legal product responsibility.
• This product is not a toy. Keep out of reach of children.
• Keep batteries out of the reach of children. Dispose of batteries as chemical
waste. Never use old and new batteries or different types of batteries together.
Remove the batteries when you are not using the system for a longer period of
time. Check the polarity (+/-) of the batteries when inserting them in the product.
Wrong positioning can cause an explosion.
• Automatic switching devices provide comfort, but can also be dangerous. They
can surprise people or can ignite clothing hanging over an electric heat source.
Please be careful and take appropriate measures to avoid accidents.
MAGNETIC CONTACT (DS831)
The DS831 is a magnetic contact designed for installation on doors and windows.
This product is a part of the Marmitek ProGuard800 series, and operates together
with the ProGuard800 alarm system. When you wish to know more about the
complete system, its possibilities and its settings, then you can check out the
installation manual
www.marmitek.com.

INSTALLATION PROCEDURE

To install magnetic contacts.
1. To open the housing, insert a
small screwdriver at the bottom
of the unit between the front and
back cover
screwdriver to release the cover.
DS831
or visit
and twist the
Antenna
LED
Indicator
1cm max.
Operation
Mode Jumper
Location
of wiring
knockou
Figure B.3: EL-2601 (cover off)
Battery
Holder
Tamper
Switch
Loop
Terminal
PCB
Release
Tab
2