Lock Off Button; Two Speed Operation - BLACK&DECKER 9049A Manual De Instrucciones

154499/9049A/1284 5/1/02

LOCK OFF BUTTON

2
FORWARD
TRIGGER
SWITCH
8:54 AM Page 3
REVERSE
TRIGGER
SWITCH
8. Unplug your tool's charger from the power supply before
1
disconnecting the charger from the tool. Under certain
conditions, with the charger plugged in to the power supply, the
exposed charging plug can be shorted by foreign material and
may create a fire hazard. Foreign materials of a conductive
nature, such as but not limited to, steel wool, aluminum foil, or
any build up of metallic particles should be kept away from the
charging plug. Unplug charger before attempting to clean.
Lock Off Button
To prevent accidental turn on, a lock off button is provided. To lock
the drill off slide the button up. To unlock the tool, slide the button
down (Figure 1).
Trigger Switch & Reversing Button
The drill is turned ON and OFF by pulling and releasing the trigger
switch shown in Figure 2. The reversing button, shown in Figures 2
& 3, switches the drill's direction from forward to reverse.

Two Speed Operation

3
Your drill is equipped for two speed drilling. To operate at low
speed, squeeze the trigger switch halfway. This will produce a
speed of approximately 225 RPM to be used for driving screws and
starting holes without a centerpunch. Squeezing the trigger switch
all the way will produce a speed of approximately 550 RPM for
normal drilling operation.
NOTE: There is a slight pause between speeds. Keep squeezing
the trigger, and the drill will start again.
Screw Driving
For driving fasteners, the reversing button should be pushed to
the left as shown in Figure 2.
Use reverse (button pushed to the right) shown in Figure 3 for
3