Flamelux ALPS Manual Del Propieratio página 10

The figure below illustrates the control panel on the right side of the unit and the remote control.
MAIN ON/OFF SWITCH
To turn unit on, press the main ON/OFF switch from "0" to "I". The
switch will illuminate and it will beep one time. The unit will go into
standby mode. To turn it off, please press the switch from "I" to "0".
Now you can use either buttons next to the main ON/OFF switch
or remote control to control the appliance.
POWER : Press this button to turn the unit on. To turn it
back to standby mode, press it again.
Button will activate the heater on the low setting (750W).
Button will active the heater on the high setting (1500W).
OPERATING INSTRUCTIONS
9
HEATER OFF