Bond BH5002-1 Manual Del Usario página 7

5. This item requires a 20 lb. propane
tank (not included) in order to operate
correctly. To install the tank to the body
(B), first turn the cylinder valve on the
tank clockwise to close the gas supply
on the gas cylinder. Then, screw the
regulator coupling from inside the
body (B) onto the valve clockwise by
hand only. Make sure it is fastened.
OPERATING INSTRUCTIONS
Perform leak test in a well-ventilated area outside and where no source of spark can occur. DO NOT
cover firepit directly after flame is out. Wait 5 minutes for firepit to cool prior to placing lid on firepit.
Connect tank cylinder to regulator. Turn the on/off valve at the unit to the 'OFF' position to pressurize
the control system. Use a soapy water solution to check all the connection leaks before attempting to
light the appliance.
If a leak is found or you smell gas, disconnect cylinder and turn valve off and do
not use the appliance until repairs can be made.
Cover must be removed when burner is in operation.
Firebowl and propane gas cylinder minimum distance
must be over 60'' (as per the right side photo)
TO LIGHT
1. Control knob must be in the "OFF" position.
2. Connect propane cylinder (See Manual), open cylinder valve.
3. Push in knob in fully and rotate about 1/4 turn "counter clockwise" until a click is heard.
4. If ignition does not occur, repeat step 3 in rapid succession for no more than 5 seconds or until burner ignites.
If ignition still does not occur, immediately turn the burner control off, wait 5 minutes for the gas to clear and repeat
lighting procedure.
5. After ignition, continue to push and hold the control knob for 45 seconds to heat the thermocouple. Burner flame will
remain lit. If not, repeat lighting procedure.
6. Adjust flame to desired flame with the control knob.
7