Safety Information - GE AEV05 Manual Del Propietario Y Instrucciones De Instalación

IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
WARNING
For your safety, the information in this manual must be followed to minimize the risk of
fire, electric shock or personal injury.
described in this Owner's Manual.
This air conditioner must be properly installed in
accordance with the Installation Instructions before it is
used.
Never unplug your air conditioner by pulling on the
power cord. Always grip plug firmly and pull straight
out from the receptacle.
Replace immediately all electric service cords that
have become frayed or otherwise damaged. A
damaged power supply cord must be replaced with a
new power supply cord obtained from the manufacturer
and not repaired. Do not use a cord that shows cracks
or abrasion damage along its length or at either the
plug or connector end.
Turn the unit OFF and unplug your air conditioner
before cleaning.
To avoid Risk of injury or property damage, the air
conditioner should only be serviced by a qualified
servicer, who should hold a current valid certificate
from an industry-accredited assessment authority,
which authorizes their competence to handle
refrigerants safely in accordance with an industry
recognized assessment specification.
WARNING
or to clean, other than those recommended by the
manufacturer
The appliance shall be stored in a room without
continuously operating ignition sources (for example:
open flames, an operating gas appliance or an
operating electric heater
READ AND SAVE THESE INSTRUCTIONS
49-7810
This air conditioner should place in well ventilated area
to prevent accumulation of refrigerant to create a fire
or explosion hazard. Do not drill holes in base pan or
breaking into a refrigerant circuit.
For your safety...do not store or use combustible
materials, gasoline or other flammable vapors or
liquids in the vicinity of this or any other appliance.
All air conditioners contain refrigerants, which under
federal law must be removed prior to product disposal.
If you are getting rid of an old product with refrigerants,
check with the company handling disposal about what
to do.
If the receptacle does not match the plug, the
receptacle must be changed out by a qualified
electrician.
These R32 air conditioning systems require contractors
and technicians to use tools, equipment and safety
standards approved for use with this refrigerant.
Servicing shall only be performed as recommended by
the equipment manufacturer. Maintenance and repair
requiring the assistance of other skilled personnel
shall be carried out under the supervision of the
person competent in the use of flammable refrigerants.
DO NOT use equipment certified for R410a or R22
refrigerant only.
Do not pierce or burn. Be aware that refrigerants may
not contain an odor
3