Air Hammer - Smarter tools 71PC Air Tool Kit Manual De Instrucciones

7. If the tool requires more force to accomplish the task, verify that the tool
is receiving sufficient, unobstructed airflow (CFM) and the maximum air
pressure (90 PSI) is being provided.
8. DO NOT attempt to raise air pressure to get more out of the tool.
Operating the tool at a higher than maximum rated pressure can result
in damage to the tool and/or accessory and possible injury to the
operator.
9. If the tool still does not have sufficient force at maximum pressure and
airflow, then a larger tool may be required.
10. DO NOT lay the tool down until it has come to a complete stop. Moving
parts can grab the surface and pull the tool out of control.

3.5 Air Hammer

1. Select the appropriate chisel bit. With your thumb, put counterclockwise
pressure on the spring and insert the shank of the chisel bit into the
cylinder. Release the spring. Holding the Air Hammer firmly, pull the
chisel bit hard to make sure it locked into place.
2. Connect the air hose to the air inlet and turn on the compressor (not
included).
3. Grip the Air Hammer with both hands firmly and put the chisel tip up
against the workpiece you wish to chip.
4. Gently squeeze the trigger and move slowly along the workpiece. DO
NOT push down on the Hammer; let it do the work. If it does not do the
intended job to satisfaction, examine your bit to see if it is worn or dull.
When you are finished, turn off the air supply and then hold the Air Hammer in a
safe direction and Squeeze the trigger to bleed off the remaining air. Then,
disconnect the air hose.
Note:
Before connecting the air supply, make sure you are wearing
safety goggles and a full face mask, ear protection, and steel
toe shoes.
WARNING!!
ANY SPECTATORS IN THE IMMEDIATE AREA WILL NEED
EYE AND EAR PROTECTION.
BEWARE OF FLYING CHIPS OF WOOD, CONCRETE,
METAL, OR ANY OTHER MATERIAL BEING CHISELED.
3-3