LaserLiner LiveTester Plus Manual Del Usario página 10

The socket outlet with earthing contact CEE 7/4 Type F
! is not protected against polarity reversal. The warning
„L/N Reverse" should therefore also be considered
as correct. It is recommended to use uniform socket
wiring throughout the building installation.
2 FI/RCD test
!
Do NOT continue if the RCD 30 mA indicator (7)
is NOT on!
2. Before FI/RCD is tripped, make sure that no sensitive devices
(e.g. PC) will be switched off unintentionally. During the test,
the mains voltage is switched off in the entire phase circuit.
!
If the FI circuit breaker does not trip, there is
a life-threatening fault that must be rectified
by a qualified electrician.
The device is designed for performing a quick test of
!
the FI/RCD tripping function and is not a substitute
for a complete acceptance or retest in accordance with
national and international standards (e.g. EN 50110-1
(VDE 0105), (VDE 0100).
10
GB
1. Plug the device into the
socket. Make sure that the
word TOP is at the top.
3. The line-side FI/RCD circuit
breaker trips when the
„TEST" button is pressed
(3 seconds).