X
(2 used in this step)
42. Attach the Handle (17) to the front of each Door (X) with two Handle Bolts (18).
43. Pick up one Door (X) and attach the extended Hinge Arms to the Hinge Bases installed on Right Bookcase
Right Side Panel (T). Loosen the bolt on the back of Hinge Base for a comfortable fit. Align and insert the
"U" slot on Hinge Arm under the bolt head on the back of Hinge Base. Make sure that both door hinges
engage and function properly. Tighten the bolt on the Hinge Base to lock the hinges in place.
44. Repeat the same procedure to attach the other Door (X) to the Left Bookcase Left Side Panel (Q).
45. Open and close the doors to make sure they are aligned and shut correctly. If necessary, adjust the screws
for a good fit. Refer to the hinge sticker on door for adjustment.
46. Stick the Rubber Bumpers (20) on the outer corners of Doors (X) where they meet the Side Panels (Q and
T).
Assembly Instructions
18
17
Handle
⑰
Handle Bolt
(4 used in this step)
⑱
29
Rubber Bumper
(4 used in this step)
⑳