Panel Mounting - AB Quality MicroLogix Instrucciones De Instalación

Removal
DIN
Rail

Panel Mounting

Template
See back cover for panel mounting template.
Installation
ATTENTION
Mounting
Template
1. Place a screwdriver in the DIN rail latch at the
bottom of the unit.
2. Holding the unit, pry downward on the latch
Side
until the unit is released from the DIN rail.
View
Be careful of metal chips when drilling mounting holes for
your equipment within the enclosure or panel. Drilled
fragments that fall into the equipment could cause damage.
Do not drill holes above mounted equipment if the protective
debris strip has been removed.
1. Remove the mounting template from the back of this
document.
2. Secure the template to the mounting surface.
3. Drill holes through the template.
4. Remove the mounting template.
5. Mount the unit.
MicroLogix™ Ethernet Interface
Publication 1761-IN007B-MU-P
7