Ferm ETM1005 Traducción Del Manual Original página 5

d) During charging, batteries must be placed
in the well ventilated area!
Before using the tacker
• Always wear eye protection when using the
tool.
• Maintain the tool with care.
• Check for misalignment or binding of moving
parts, breakage of parts, and any other
condition that may affect the tools operation. If
damaged, have the tool serviced before using.
• Check if the slide cartridge has been fastened
properly.
• Do not use the tool in a humid environment.
• Do not use the tool on materials containing
asbestos.
Using the tool
• Do not use the tool if the switch does not turn
it "ON" or "OFF".
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Remove all staples from the magazine
after each use
3. USE
The machine must be charged before
first use.
Charging the machine (with the charger
adaptor)
Fig. B
The machine can be charged by the charger
adapter or by your USB mobile phone charger.
• If needed, connect the USB cable to the
charger adaptor by pushing its USB plug in the
charger adaptor's USB socket.
• Plug the small cable plug into the machine's
charging socket.
• Plug the charger into an electrical outlet and
wait for a while. The LED indicator on the
machine will lighten up and show the charging
status.
Charging the machine (on a USB socket)
Fig. C
• If needed, remove the USB cable from the
charger adaptor by pulling it out of the USB
socket.
• Plug the small cable plug into the machine's
charging socket.
• Plug the cable USB plug into USB device (for
example on your mobile phone charger).
• Make sure the USB device is powered or
switched on.
• Check charging status by checking if the
charging indicator light on the machine is
burning.
Charging indication light
Fig.A
The machine has a charging indication light which
indicates the status of the charging process:
LED color Status
Red Battery charging in progress
Green Battery charging finished, battery fully charged
• After the battery is fully charged remove the
charger plug from the outlet and remove the
cable from the machine.
Lithium-Ion cells can be stored for a long
period without losing much of their
charge. When the machine is not being
used over a longer period of time it is
best to store the battery in charged
condition.
Application
Fig. 2
For this tool, use one of the following types
staples:
• U Type 530: 6-12 mm
Loading the tacker
Before opening the tool, make sure the
tool is switched off.
To load the tacker
Fig. 3 - 4
Replacing staples
• Press the slide unlock (2) to unlock the slide.
5