Delivery Inspection; Essential Circuit Isolation - Briggs & Stratton 01917 Manual De Instalación Y Del Operario

Delivery Inspection

After opening the carton, carefully inspect the transfer
switch components for any damage that may have occurred
during shipment.
If loss or damage is noted at time of delivery, have the
person(s) making delivery note all damage on the freight bill
and affix his signature under the consignor's memo of loss
or damage. If loss or damage is noted after delivery, contact
the carrier for claim procedures. Missing or damaged parts
are not warranted.
Shipment contents
• Automatic transfer switch (1)
• Installation and operator's manual (1)
To be supplied by installer:
• Connecting wire and conduit
• Various specialty tools/equipment
240V
120V To Sump Pump
6
To Utility Power
To Range
To Water Heater
To generator
120V To Microwave
120V To Bathroom
240V To Well Pump

Essential Circuit Isolation

Essential electrical loads are loads that will be powered by
the home generator. Essential loads are grouped together
and wired into the transfer switch.
TO THE INSTALLER: Consult with home generator owner(s)
to discuss their selection of "Essential Circuits".
Ensure that the total of the selected load circuits fed by this
transfer switch are within the generator's rated capacity.
The following requirements apply to this type of
isolation system:
• The automatic transfer switch is installed after the main
distribution panel.
• The automatic transfer switch has a load rating of
50 Amps. This is the maximum load rating of the total
essential load.
• All wiring must conform to national, state and
local codes.
The illustration below depicts the system installation and
assumes the utility is supplying 120/240 Volt, single-phase
electrical service.
To Air Conditioner (240V)
To Other Circuits (120V)
120V To Freezer
To Refrigerator
To Lights
To Furnace Blower
Neutral
Watt-Hourrmeter
Main Distribution Panel
Automatic Transfer Switch
(in normal position)
120V
BRIGGSandSTRATTON.COM