CREATE THE BUBBLES
1st
2nd
3rd
*When inserted correctly there is a gap between the bottom of the carbonating bottle and the base.
Do not carbonate if the carbonating bottle is resting on the base or the water will splash out.
8
1. Prior to making soda, fill the carbonating
2. To insert the carbonating bottle, make sure
Fill Line
3. Push down the carbonating block, hold for
4. When the desired level of carbonation is
bottle with cold water up to the fill line.
that the carbonating block is in its fully upward
position and the bottle rest is angled forward.
If it isn't, pull it towards you until it clicks. Do
not pull the carbonating tube.
Insert the carbonating bottle neck into the
Snap-Lock. Push the bottle up and back. The
Snap-Lock mechanism will catch the bottle
and hold it in a vertical position.*
1-2 seconds and release. Wait for the
carbonating block to return to its fully upward
position, then repeat to obtain stronger levels
of carbonation. (See 'Carbonating Levels'
section.)
achieved, with the carbonating block in its
fully upward position pull the bottle towards
you to release it from the Snap-Lock. Enjoy!
3rd
1st
2nd